In the old days the builder would install the trim bring the siding up to it and caulk the corner.
Caulking old wood siding.
The siding expands and contracts with temperature and humidity.
Here are the step by step procedures as discussed in our painting and stripping old wood siding overview page.
Sometimes the old caulk in the siding joint is cracked and you need to cut the old caulk out with a razor knife.
When it comes to things like old windows traditional glazing putty is a much better choice.
As homeowners with this kind of siding know wood naturally expands and contracts with fluctuations in temperature and precipitation.
Wash it down with a hose once the caulk has dried the outbuilding can be given a good rinsing with a garden hose and scrub brush to knock off dirt sawdust and other debris that may prevent paint.
It is generally not a good idea to use caulking on wood siding.
Carefully use a pry bar to remove the siding.
Apply an epoxy consolidant to soft wood and coat the rest with.
Placing caulk over large portions of wood siding prohibits the natural movement of the wooden panels and can cause extensive damage to the exterior.
Remove the old siding.
Trim boards that sit on top the siding.
Here s how to make the right choice.
Siding windows and doors.
Caulk by its adhesive nature will try to limit this movement leading to widespread failure and cracking in the caulk over time.
Elastomeric polyurethane latex or silicone.
Be sure to remove any caulk where the siding overlaps as old houses need to breathe.
Think of a wood home as a living thing.
Score the calk on the edges as the ends split easily.
Fill any dents and holes with either a wood or epoxy filler.
The caulk not only protects the wood but gives a nice clean look to the architectural details of the structure by removing shadow lines.
These siding joints can be caulked successfully if the gap is wide enough for the caulk to get into the crack.
Pull out loose nails and renail using stainless steel siding nails.
Painting and repairing old wood siding step by step.
Removing all the silicone is difficult to accomplish as there is almost always some residue and when you remove it from wood it inevitably grips onto the wood fibers and pulls them with it resulting in a mutilated work piece that requires lots of repair.
When you try to restrict either it is at your peril.
If the siding joint is so tight that the caulk only bridges the gap it may split again.
On most new homes the trim goes up after the siding is installed which creates a large gap that should not be caulked.